欢迎光临 深圳市富锦纺胶膜有限公司 官方网站,我们将免费为您提供样品试用并协助您开发新产品。
0755 - 8884 0106
手压式烫膜机操作过程
2023-05-08 15:10:14

操作过程:
    1、插上电源,打开电源总开关,电源指示灯随即着亮;(注意:整机必须有合适牢靠的保护地线);将恒温器调较至所需温度(通常为130℃-200℃,如AAA级环保料烫膜温度一般为130℃-160℃);将定时器调较至所需时间(通常为5至20秒左右);
    2、当发热板温度上温到指定温度时先在发热板平铺3到5层热熔膜(按膜的厚度而定),注意铺平最好不要有气泡;
    3、将绣好的绣品有膜的一边平铺发热板上,注意铺平;
    4、手动压下压力手柄,等到时间倒数到“0”时拉上压力手柄;
    5、取下绣品即可(如果还有部分烫剥不干净可重复第3第4步)。

Operation process:
    1. Plug in the power supply, turn on the main power switch, and the power indicator light will be on; (Note: the whole machine must have a suitable protective ground wire); adjust the thermostat to the required temperature (usually 130 °C-200 °C) For example, the AAA grade environmentally friendly material film temperature is generally 130 ° C -160 ° C); adjust the timer to the required time (usually about 5 to 20 seconds);
    2. When the temperature of the heating plate reaches the specified temperature, firstly spread 3 to 5 layers of hot melt film on the heating plate (depending on the thickness of the film), it is best not to have bubbles when laying the flat;
    3, the embroidered embroidery has a film on one side of the flat heating plate, pay attention to flatten;
    4. Manually press down the pressure handle and wait until the time counts down to “0” to pull the pressure handle;
    5, remove the embroidery (if there is still some hot peeling is not clean can repeat the third step 4).

热熔膜知识
联系方式
CONTACT US

电话:0755 - 8884 0106

网址:www.fujinfang.com

地址:广东省深圳市龙岗区吉华街道甘坑社区秀峰工业城A2栋

关闭
用手机扫描二维码关闭

富锦纺胶膜微信公众号

技术QQ
售前QQ
技术微信
业务代表